Re: TANK STICKER CORVETTE
 

Drill some starting holes in the empty and rinsed tank and then take a jigsaw/sawzall or tin snips and cut it out leaving a metal margin around the outside. Then you can take the cutout piece and finish the sharp edges on your bench grinder.

Re: TANK STICKER CORVETTE
 

ALL GREAT TIPS GUYS I KNOW THAT WITH KNOWLEDGE OF THE GUYS HERE ON THIS SITE THAT I WOULOD GET SOME GREAT ANSWERS. I WILL KEEP EVERY ONE POSTED IF I GO LOOK AT THE CAR.
LES

Re: TANK STICKER CORVETTE
 

If you have other paperwork, cover it and leave it on the tank after taking good pictures.

Re: TANK STICKER CORVETTE
 

[ QUOTE ]
The best way is to leave it on the tank and install another tank. Just a opinion....

[/ QUOTE ]

There's a good chance the tank has pin holes on the bottom anyway. I hardly ever saw a Corvette tank that didn't have an inch or so of water in the bottom.
I had to replace the tank in my '68 and still have it (with the sticker attached) stored above my garage. The car is long gone but much of the stuff I replaced is still around. BTW, Anyone need a complete smog pump and brackets for a '68 427 Corvette? https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Re: TANK STICKER CORVETTE
 

Maybe be off the topic a bit, but if one choses to cut or repair a tank, after it is cleaned out, through in a few pounds of dry ice. That will displace the 02 and may keep you off the local news too.
I have seen some old welders ( like Shoney. https://www.yenko.net/ubbthreads/imag...mlins/grin.gif) use this trick on small aircraft tanks.