Re: Wrecked 1970 TA on ebay
 

$2500 a quarter? $2000 a fender? Really? Why would an engine rebuild be so much? Even with a block that needs 8 sleeves it should be cheaper. I whould worry about head corrosion more than block corrosion. I'm not saying it would be cheap, but those prices seem a bit on the outrageous side.


Jason

Re: Wrecked 1970 TA on ebay
 

At the Trans Am Nationals last year a used rust free original front fender for this car was $1800.

Brian

Re: Wrecked 1970 TA on ebay
 

[ QUOTE ]
$2500 a quarter? $2000 a fender? Really? Why would an engine rebuild be so much? Even with a block that needs 8 sleeves it should be cheaper. I whould worry about head corrosion more than block corrosion. I'm not saying it would be cheap, but those prices seem a bit on the outrageous side.


Jason

[/ QUOTE ]

1) It's a Pontiac, not a Chevrolet. Engine parts cost a ton more than a small block or big block Chevy.

2) If you want the correct parts for a 70-72 Firebird you will pay dearly for them. Nothing interchanges with the same era Camaros despite the fact that most venders falsely describe them as fitting both models. https://www.yenko.net/ubbthreads/imag...s/rolleyes.gif
I've seem major allegedly reputable venders selling 70-73 Camaro and Firebird rear quarters with the same part number and 70-81 Camaro and Firebird door skins with the same part number even though the two cars have completely different body lines.

3) I have been lucky with my project. The only NOS body parts it needed were the driver's door skin, the lower front spoiler and the tail light panel. I lucked into an NOS door skin on ebay that the guy misdescribed as a later door skin. I found out when I had him email me back the door handle opening measurements. I think I picked it up for $300...and it was local, too! It was an absolute steal because the early style "long door handle" door skins never show up for sale since they were only offered as a service part from 1970 to 1972. The same thing happened with the front spoiler and the rear fiberglas tail light panel - misdescribed and bought reasonably cheaply!

4) Yeah, you could throw on a couple of 73 to 81 fenders and hood on the car and 95% of the people out there won't know the difference. You could also buy some repro quarters for $150 too, and repro doorskins that have the wrong later model door handle openings. You could bolt up a later model radiator support that has those easily spotted 73-81 front fender bracket indents instead of the unobtainable flat top 1970-72 support (another $2000+ piece) - no one will really notice.

You could cut a lot of corners with the bad repro stuff out there and maybe do the car for a whole bunch less but it won't be correct.

It's the same thing with First Gen Camaros, and even Mopars. You can restore a Copo to look presentable to 95% of the population but it won't be correct. That is the difference between the $100,000 Copo (with the Ford "CAUTION FAN" sticker on the shroud) and the $400,000 Copo (without the aforementioned sticker). Or the $125,000 Hemicuda (with the brand new Mopar Performance crate motor) and the $500,000 Hemicuda (with it's born-with block). It's all in the process, the parts, and the execution.

A correct restoration means different things to different people. I prefer to do my cars to a certain level of insanity and try not to deviate from that self-imposed, financially ludacris, standard. On my T/A I am trying to refurbish and reinstall as many of the original components that were on this exact car back in 1972 as I can. (which is why I am just about broke now https://www.yenko.net/ubbthreads/images/graemlins/no.gif)

Re: Wrecked 1970 TA on ebay
 

I understand your point Steve. What parts on this car are different from a standard Firebird or Formula? Couldn't a guy find a dry 70 Firebird and use many of the parts off of it? Are Trans-Am parts that specific? I know the fenders have the cut outs but couldn't they be grafted from the original fenders? Is the core support different between a Trans-Am and standard Firebird? What about the quarters? Dash? It seems like a guy could find a nice original 70 Firebird and have most of the parts he needed since the Trans-Am specific stuff is there. Unfortunately, because of this Matt may be right. It could be a rebody waiting to happen. It just seems to me that door skins are not necessary if you can find clean doors, etc.


Jason

Re: Wrecked 1970 TA on ebay
 

[ QUOTE ]
I understand your point Steve. What parts on this car are different from a standard Firebird or Formula? Couldn't a guy find a dry 70 Firebird and use many of the parts off of it? Are Trans-Am parts that specific? I know the fenders have the cut outs but couldn't they be grafted from the original fenders? Is the core support different between a Trans-Am and standard Firebird? What about the quarters? Dash? It seems like a guy could find a nice original 70 Firebird and have most of the parts he needed since the Trans-Am specific stuff is there. Unfortunately, because of this Matt may be right. It could be a rebody waiting to happen. It just seems to me that door skins are not necessary if you can find clean doors, etc.


Jason

[/ QUOTE ]

Oh, yes a lot of parts are interchangable with a regular 70-72 Firebird but it's really hard to find a rust free example as a donor car. For example, the flat top radiator supports rusted from the battery being bolted to them and an overall poor design. The doors were unique so you have to find a 70-72 car with rust free doors which are really rare. The early second gen Firebirds and Camaros had a serious rust problem with the lower rear frame rails and it's really hard to find a car that does not have that problem, too. The dash pads are the same up to about 1975 so you have a larger hunting area there but they all cracked and warped, and it's really hard to find a nice unmolested one with the radio hole intact. These pads were one gigantic piece of vinyl that encompassed the entire front dash area from the windshield to the knee bolster area. Unfortunately the area where the radio goes was just another piece of unrepairable plastic and vinyl that everyone hacked out with a saw to install that high fidelity Kraco AM/FM/CB stereo back then.

Re: Wrecked 1970 TA on ebay
 

Hmmmm, maybe I should start parting them out out here.


Jason

Re: Wrecked 1970 TA on ebay
 

If you end up buying this car, I have a very solid running 71 6cyl Bird, a perfect 72 T/A front clip, and a nice 71 black dash. And I would KILL, to get half what NJSteve is quoteing for these parts. But I am in Alaska.

Aperently I need to list this stuff on ebay, I didn't know I was sitting on a gold mine. https://www.yenko.net/ubbthreads/imag...lins/dunno.gif
71 bird,
http://s95.photobucket.com/albums/l1...71%20firebird/
72 T/A front clip (the red one),
http://s95.photobucket.com/albums/l1...%20am%20parts/

Re: Wrecked 1970 TA on ebay
 

AK, that's some really neat stuff. I guess the deepfreeze there keeps things preserved pretty well. I dont think I've ever seen a 6 cyl Firebird before. And yes, the fenders and radiator support on that car worth some $$$. I would not part that car out, though. I also can't imagine the shipping costs of sending big parts south.

As for the parts prices, go to the forums on Performanceyears.com and check the Firebird parts wanted and for sale section. Right now there's an NOS quarter for $1800, with crating and shipping thats more than $2000 right there.

Re: Wrecked 1970 TA on ebay
 

-----I went to an estate auction near me several years ago on a farm. There were four 63/67 Vettes advertised in the flyer. When I got there it was plain to see that none of the cars were buildable in any sense of the word. I left soon after as I had no interest in "parts cars". I heard later thru the grapevine that the cheapest one went for $6000ish. It took me awhile but I eventually figured out that, more than likely, they were all bought for the tags and titles. I humbly suggest that this may be happening here. Somebody out there has a T/A with bad numbers and wants only the serial tag. Unfortunate!!! https://www.yenko.net/ubbthreads/imag...emlins/mad.gif https://www.yenko.net/ubbthreads/imag...emlins/mad.gif https://www.yenko.net/ubbthreads/imag...emlins/mad.gif.......Bill S

Re: Wrecked 1970 TA on ebay
 

Steve knows his stuff. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Pontiac really tried to breakout the Firebird from the Camaro early on. The 67-68 models shared many of the same parts between them, the 69 Camaro and Firebird only shared door panels and trunk lids, and the 70-up Firebird and Camaro were very different from each other. One of the problems in restoring a Firebird is that the Camaro restoration vendors decided about 15 years ago that they could market to Firebird owners by simply changing their description(s) to say "Fits Camaro/Firebird". Over the years, as more and more Firebirds were restored, owners simply went with what was cheap and convenient, what was in the catalog, and Firebird restorations became inundated with reproduction Camaro parts. And now, all these years later, some of those cars are getting re-restored, and due to aging and weathering, it's tough to know what's original and what's an older reproduction Camaro part.

As Steve stated, you can make nearly any 70-up part fit your 70 Trans Am, but for a good resto, the afficiandos will know which parts are from incorrect years, which parts are resto parts, and which parts are Camaro parts. I learn more everyday about the subtle differences between the Camaro and the Firebird. The 1969's are sort of a nightmare to restore, because they a one-year only body and interior.