Re: General LT-1 Information
 

I'm picking up the heads tonight, no 'cheatin' done to them, just getting them relooked at while I had the engine down for the cam swap.

I originally installed a Comp Cams with a little more lift, and a little less duration, but with a lot less 'overlap' in an effort to increase cylinder pressure and therefore bottom end torque. After learning a little more about cams from Pete, Rob and others, I realized that this cam was not what I really wanted, and that the stock cam is the best. So, I tore it down, and found some other issues to straighten out, (like a little valve cover oil leak, cracked oil sending switch, etc...) but now am in the rebuilding stage.

Anyone want to suggest the easiest way to degree a cam, without buying the whole degree kit?

Re: General LT-1 Information
 

Isn't there cam bottons made? I think they have different degrees in them like 3 degress advanced and so. I would call Crane and ask them what they advise, Maybe put it in straight up. Line the marks up. I would make a call though. Going to see you at Lansdale: (Under The Lights) Same weekend as GM Carlisle. Sat. nite Sam

Re: General LT-1 Information
 

Sam is right call crane --it will save you a lot of trial work---

Re: General LT-1 Information
 

[ QUOTE ]
.....no 'cheatin' done to them, just getting them relooked at while I had the engine down for the cam swap....

[/ QUOTE ]

Uh huh ...... that's what they all say ...... https://www.yenko.net/ubbthreads/imag...ns/naughty.gif https://www.yenko.net/ubbthreads/imag...ins/3gears.gif

Re: General LT-1 Information
 

Casey, you must have a guilty conscience.

Re: General LT-1 Information
 

[ QUOTE ]
Casey, you must have a guilty conscience.

[/ QUOTE ]

They told me if I wore the dress and the high heels, they'd pay me $100. I was young back then, and needed the money.....

....oh wait, you're not talking about that ........ https://www.yenko.net/ubbthreads/imag...lins/blush.gif

Re: General LT-1 Information
 

We told you,we left your money on the Nightstand Casey! https://www.yenko.net/ubbthreads/imag...emlins/mad.gif

Re: General LT-1 Information
 

Just get that car back together Marlin......you have an obligation to meet on Labor Day weekend...if you don't show I will just assume that you forefitted and are scared.....

Re: General LT-1 Information
 

I'm workin on it! The heads are back on, the Crane Blueprint cam is in, lifters and pushrods, along with the timing chain and gears. I hope to have the chain cover on, water pump and the intake installed, and the valves adjusted by the weekend. Then, it's the small stuff!

Re: General LT-1 Information
 

Good to hear, M! https://www.yenko.net/ubbthreads/imag...lins/beers.gif