Forum: Chevrolet
01-04-2026, 07:38 PM
|
|
Replies: 41
Views: 7,283
|
|
Forum: Chevrolet
01-03-2026, 02:16 AM
|
|
Replies: 84
Views: 24,364
|
|
Forum: Chevrolet
01-02-2026, 08:36 PM
|
|
Replies: 84
Views: 24,364
MSD Mount
https://i.imgur.com/EXCSAGPh.jpg
Completed a small project over New Year’s day: I fabricated a mount for the MSD box (actually I fabbed two because I made a mistake on the first one…”no job is...
|
|
Forum: Supercar/Musclecar Discussion
12-31-2025, 01:02 PM
|
|
Replies: 8
Views: 1,002
Is This Mick Price’s “Old” Camaro At Mecum?
Note the description…Powerglide automatic when clearly there’s a Muncie in the car. Who writes this stuff for Mecum?
https://www.mecum.com/lots/1163307/1969-chevrolet-camaro-coupe/?aa_id=744081-0
|
|
Forum: Chevrolet
12-22-2025, 11:43 AM
|
|
Replies: 84
Views: 24,364
[QUOTE=RPOLS3;1685428]Schwing![/
Thanks! Way...
[QUOTE=RPOLS3;1685428]Schwing
I’m certainly no expert but Canadian Pontiac’s...
I’m certainly no expert but Canadian Pontiac’s had Chevy floor pans. Quarter panels were shorter than American cars, front fenders were shorter. Basically a Chevy with Pontiac styling. You can really...
|
|
Forum: Chevrolet
12-20-2025, 04:56 PM
|
|
Replies: 84
Views: 24,364
Another round of fixes and re-restoration
Some parts arrived (some didn’t…backorders again…) so I was able to get more done on my Corvette.
Out back, the gas tank emblem wasn’t right. It was bent (!) and low and behold, the nuts that...
|
|
Forum: Supercar/Musclecar Discussion
12-20-2025, 12:12 PM
|
|
Replies: 13
Views: 1,511
|
|
Forum: Lounge
12-15-2025, 03:44 PM
|
|
Replies: 15
Views: 1,282
|
|
Forum: Chevrolet
12-13-2025, 08:45 PM
|
|
Replies: 544
Views: 382,974
|
|
Forum: Ebay & other seen ads section
12-05-2025, 12:50 AM
|
|
Replies: 24
Views: 3,545
Way Back When...
I’ve shared these before, but here’s my 71 LS6 in I believe early to mid 1974: https://i.imgur.com/6nqrQY8h.jpg
https://i.imgur.com/ycUPtxqh.jpg
https://i.imgur.com/0LEsxz6h.jpg
My clone (shown...
|
|
Forum: Chevrolet
12-03-2025, 10:52 PM
|
|
Replies: 84
Views: 24,364
No Shortcuts...
https://i.imgur.com/ItgrjFoh.jpg
I had a very recent conversation with someone over my Corvette sale and this came up. And it’s a legitimate question and concern: “Now that you might sell it,...
|
|
Forum: Supercar/Musclecar Discussion
12-03-2025, 09:59 PM
|
|
Replies: 2
Views: 581
|
|
Forum: Boulder Motorcar
12-03-2025, 04:55 PM
|
|
Replies: 171
Views: 109,334
|
|
Forum: Boulder Motorcar
12-02-2025, 04:30 PM
|
|
Replies: 171
Views: 109,334
|
|
Forum: Chevrolet
11-30-2025, 11:34 PM
|
|
Replies: 84
Views: 24,364
Sale???
I’ve mentioned this to a couple of folks from the forum, and I wasn’t 100% sure about this, but I am now, so here goes:
I really (Really) miss my old Nova Plain Jane. I have serious buyer’s...
|
|
Forum: Chevrolet
11-29-2025, 09:53 PM
|
|
Replies: 84
Views: 24,364
Little Fixes...
I’ve devoted some time to little fixes on the Vette (and boy howdy are there enough of them…L-O-L). Here are a few…
First was the swiss cheese job on the passenger side door sill. There are four...
|
|
Forum: Chevrolet
11-28-2025, 05:43 PM
|
|
Replies: 84
Views: 24,364
Rear Wire Harness
The next task was to install a new rear wire harness (tail light and rear portion of the car). I used a Summit Racing brand harness, and it's a great quality product (absolutely zero fit or component...
|
|
Forum: Chevrolet
11-28-2025, 05:11 PM
|
|
Replies: 84
Views: 24,364
My attempt to beat the heat...
With an early Corvette, there’s a lot of heat and noise transferred to the cockpit, so my plan was to reduce it if possible. I chose Hushmat as the initial step (I’ll use the OEM style rubber and...
|
|
Forum: Chevrolet
11-25-2025, 01:39 AM
|
|
Replies: 84
Views: 24,364
L-O-L… if I was younger and had more money I...
L-O-L… if I was younger and had more money I think I’d be dangerous :) … I’m actually thinking long and hard about building a “sequel” to Plain Jane the Nova I built a few years ago.. I have to...
|
|
Forum: Chevrolet
11-24-2025, 10:03 PM
|
|
Replies: 84
Views: 24,364
Power Window Installation...
It was my plan from the beginning to install power windows in the Corvette. Since the interior was out, it was a pretty straightforward task, but there were a few, uh, learning moments…L-O-L
I...
|
|
Forum: Parts/Memorabilia - For Sale
11-23-2025, 03:37 PM
|
|
Replies: 0
Views: 339
Miscellaneous C3 Corvette Parts
Corvette Parts For Sale
The following parts were removed from my 1971 NCRS Top Flight Restored Corvette (small block 350-270 manual transmission, standard suspension application without AC car). ...
|
|
Forum: Chevrolet
11-22-2025, 07:50 PM
|
|
Replies: 84
Views: 24,364
Removable Transmission X-Member
Accomplishing a transmission R&R on a C2 or most C3 Corvettes with a stick is a royal pain in the you know where. To remove the gear box, you have to first remove the driveshaft and shove it out of...
|
|
Forum: Chevrolet
11-15-2025, 08:11 PM
|
|
Replies: 84
Views: 24,364
|
